Make sure there is no bathroom or a shower on the other side of that wall. Using a Stud Finder, locate a good location between two wall studs at approx. Using a hand held drywall saw, cut the dry wall according to the marking. Remove the drywall cutout and make sure there are no interference inside the wall to install the safe 6. Insert the safe into the wall and install to the wall studs from the inside of the safe using the lag bolts provided.
It is recommended to drill pilot holes for bolts. Personal code digit for an every day regular use. Master code 6-digits will override the personal code in case it was lost or forgotten. Step 1. Shut the door and hold it closed all the way with one hand. Note: You have 10 minutes to press and close the safe from the time it was opened.
To close the safe now, you must enter your personal code and press e. Step 3. Open the safe with your personal code or factory code if it was never changed before. The scanner will flash red. While the scanner flashes red immediately place your finger preferably your index flat on the fingerprint scanner wait until the scanning process is done and the green LED goes on twice with two beeps. Remove your finger from the scanner, your fingerprint is now enrolled.
NOTE: To add additional fingerprints, repeat step 3. You can enroll up to 30 different fingerprints. Open the safe and leave the door open 2. Remove one of the batteries from the battery box inside the safe 3. Press and hold the wake-up button for 3 seconds and release. Press and hold the red setup programming button, while holding the button insert the battery back into the battery box.
Keep holding the red setup button until the LED indicator flashes green twice with 2 beeps. Release the setup button and the safe is now initialized back to factory settings. Now any fingerprint can open the safe Using the Emergency override key: Setup Button Deleting: To delete fingerprints users , go to: Initialization Process You cannot delete individual users. You must delete all users. Open the door and turn the knob so the bolts are out Locked position.
Press the pound key 2 times This will enter the lock into a code-change mode and orange LED will light up. Model Number: Date of Purchase: Notes: 5. Check your new code by entering your code and then. We recommend that you right your new digit code on a piece of paper to avoid any errors when programming.
TIPS: Your code must consist of 4 to 10 digits Always press the key after the last digit to open Check your new code at least 3 times with the door open before you close the safe. In the event of a defect in materials or workmanship covered by this warranty, the purchaser shall return, at purchaser's expense, the product to Protex Safe Co. Repair or replacement shall be at the election of Protex Safe Co. The purchaser's sole remedy shall be the repair or replacement of the product and under no circumstances shall Protex Safe Co.
In no event shall Protex Safe Co. This warranty and remedies set forth above are exclusive and in lieu of all others, oral or written, expressed or implied. No dealer, distributor, agent or employee is authorized to make any modification or addition to this warranty.
Some states do not allow the exclusion or limitation of implied warranties or limitation of liability for incidental or consequential damages, so the above limitation or exclusion may not apply to you.
0コメント